powered by
The frame of the device is based on the SLH 1 design but is equipped with manual hydraulic units. It is a more economical version while maintaining the comfort of the operator. The individual hydraulic units are controlled directly on a specific press collet. You can use the basic design of the press with four pressing units to press joints and prisms. For pressing frames (doors, windows) it is enough to extend the basic frame by side mechanical pressure. The frame press takes up only a fraction of the space required for less efficient pressing methods. Thanks to the increase in the efficiency of your work, the money invested will return to you very quickly.
Hydraulic collet SLH 2
Pressure bar for SLH 1, 2 and SLT 1
Side pressure
| Main dimension – height x width x length | 2100x700x3200 mm |
| Work table dimensions width x height | 2500×1500 mm |
| Maximum thickness of glued material | 90 mm |
| Number of vertical collets with hydr. cylinder | 4 ks |
| Number of pressure rails | min. 1 piece |
| Hydraulic cylinder stroke | 90 mm |
| Pressing pressure max. | 3 t |
| Pressing pressure of the side mechanical unit | 2,5 t |
